Table of Contents
Advertisement
This model is equipped with a self-diagnosis
device for various electrical circuits.
If a problem is detected in any of those circuits,
the engine trouble warning light comes on and
the display indicates an error code.
The self-diagnosis device also detects prob-
lems in the immobilizer system circuits.
If a problem is detected in the immobilizer sys-
tem circuits, the immobilizer system indicator
light flashes and the display indicates an error
code.
TIP
If the display indicates error code 52, this could
be caused by transponder interference. If this
error code appears, try the following.
1. Use the code re-registering key to start the
engine.
TIP
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal
interference, which may prevent the engine
from starting.
2. If the engine starts, turn it off and try start-
ing the engine with the standard keys.
3. If one or both of the standard keys do not
start the engine, take the vehicle, the code
re-registering key and both standard keys
to a Yamaha dealer and have the standard
keys re-registered.
If the display indicates any error codes, note
the code number, and then have a Yamaha
dealer check the vehicle.
ECA14B1017
If the display indicates an error code, the
vehicle should be checked as soon as pos-
sible in order to avoid engine damage.
Display brightness, shift timing indicator
light and throttle opening position display
control mode
1. Shift timing indicator light activation range
2. Shift timing indicator light
3. Brightness adjustable displays
4. Brightness level
This mode allows you to make changes to six
settings by performing the following steps.
1. Turn the key to "OFF".
2. Push and hold the "SELECT" button.
3. Turn the key to "ON", and then release the
"SELECT" button after five seconds. The
display brightness function is selected.
4. Push the "SELECT" button to switch the
functions in the order below.
a. Display brightness:
This function allows you to adjust the
brightness of the displays and tachome-
ter to suit the outside lighting condi-
tions.
b. Shift timing indicator light activity:
This function allows you to choose
whether or not the indicator light should
be activated and whether it should flash
or stay on when activated.
c. Shift timing indicator light activation:
This function allows you to select the
engine speed at which the indicator
light is activated.
d. Shift timing indicator light deactivation:
This function allows you to select the
engine speed at which the indicator
light is deactivated.
e. Shift timing indicator light brightness:
This function allows you to adjust the
brightness of the indicator light to suit
your preference.
f. Throttle opening position display:
This function allows you to choose
whether or not to show the throttle
opening position display.
1-13
FEATURES
Advertisement
Table of Contents
Troubleshooting
