Yamaha 2009 YZF-R1 (Y) Service Manual page 87

1. Meter lead
2. Ground lead
3. Meter
4. Meter bracket
5. Right auxiliary light lead
6. Headlight sub-wire harness
7. Headlight lead
8. Intake air temperature sensor
9. Left auxiliary light lead
10.Right air intake air duct cover
11.Turn signal relay
12.Headlight relay
13.Left air intake air duct cover
A. Make sure to insert the coupler and boots
into the meter. Edge of the boots should
not turn inward/outward.
B. The meter lead should not protrude out.
C. Direction of the ground lead should be
within the area shown in the illustration.
D. The ground lead should not protrude out.
The ground lead terminal can be in any
side.
E. Route the auxiliary light lead under the
front intake air duct and connect.
F. To the main harness
G. To the turn signal
H. Cut off the excess end of the clamp.
I. When clamping the headlight sub-wire har-
ness, it should not be sagged. Face the
end of the clamp to front.
J. Route the headlight lead toward the front of
the meter bracket and connect.
K. To the meter
L. Fix the turn signal relay by inserting it all
the way in to the headlight right rib.
M. The turn signal relay and headlight relay
can be installed either right/left.
N. Secure the headlight relay by inserting it all
the way in to the headlight left rib.
O. The auxiliary light lead should not be
pinched when installing the air intake air
duct cover. Fit it inside of the console
panel.
2-50
CABLE ROUTING