Yamaha 2009 YZF-R1 (Y) Service Manual page 218

Table of Contents

Advertisement

TIP
Use the side of the rod holder that is marked
"B".
c. Hold the spring preload adjusting bolt "6"
and loosen the nut "3".
ECA14B1005
When loosening the nut "3", be sure not to
break the projections "a" on the cap bolt
collar "7" of the cap bolt "1".
TIP
Loosen the nut using a proper tool that has a
thickness "b" of 4.0 mm (0.16 in) or less.
d. Remove the cap bolt.
e. Remove the rod holder and fork spring
compressor.
f. Remove the nut and spacer.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Drain:
• Fork oil
TIP
Stroke the damper rod "1" several times while
draining the fork oil.
4. Remove:
• Dust seal
• Oil seal clip "1"
(with a flat-head screwdriver)
• Oil seal
• Washer
5. Remove:
• Damper rod assembly
ECA14B1048
For the damper rod assembly, the right side
is used for the rebound operation and left
side for the compression. Pay attention not
to mistake the right and left.
TIP
Remove the damper rod assembly with the
damper rod holder "1".
Damper rod holder
90890-01506
YM-01506
4-63
FRONT FORK

Advertisement

Table of Contents
loading

Table of Contents