Sensor Operation Table - Yamaha 2009 YZF-R1 (Y) Service Manual

Sensor operation table

Diag-
nostic
code
No.
D:01 Throttle position sensor sig-
nal 1
• Fully closed position
• Fully opened position
D:02 Atmospheric pressure
D:03 Pressure difference
(atmospheric pressure and
intake air pressure)
D:05 Intake air temperature
D:06 Coolant temperature
D:07 Vehicle speed pulse
D:08 Lean angle sensor
• Upright
• Overturned
D:09 Fuel system voltage
(battery voltage)
Item
12–21
97–106
Displays the atmospheric
pressure.
Displays the intake air pres-
sure.
When engine is cold: Dis-
plays temperature closer to
air temperature
When engine is hot: Air tem-
perature + approx. 20°C (68
°F)
When engine is cold: Dis-
plays temperature closer to
air temperature
When engine is hot: Displays
current coolant temperature
0–999
0.4–1.4
3.7–4.4
Approximately 12.0
FUEL INJECTION SYSTEM
Meter display
8-39
Checking method
Check with throttle valves
fully closed.
Check with throttle valves
fully open.
Compare the actually mea-
sured atmospheric pressure
with the meter display
value.
Set the engine stop switch
to " ", and then push the
start switch " ". (If the dis-
play value changes, the per-
formance is OK.)
Compare the actually mea-
sured intake air temperature
with the meter display
value.
Compare the actually mea-
sured coolant temperature
with the meter display
value.
Check that the number
increases when the rear
wheel is rotated. The num-
ber is cumulative and does
not reset each time the
wheel is stopped.
Remove the lean angle sen-
sor and incline it more than
45 degrees.
Set the engine stop switch
to " ", and then compare
with the actually measured
battery voltage. (If the bat-
tery voltage is lower, per-
form recharging.)