Yamaha 2009 YZF-R1 (Y) Service Manual page 105

1. Rear frame
2. Right upper tail cover bracket
3. License plate light lead
4. Right turn signal light lead
5. Left turn signal light lead
6. Battery box 2
7. Tail/brake light lead
8. Lean angle sensor lead
9. Left upper tail cover bracket
10.Main harness
11.Starter relay
12.Front frame
13.Battery negative lead
14.Battery box 1
15.Clamp
16.Starter motor lead
17.Battery positive lead
18.Tool band
19.Battery
20.Battery seat
21.Tool
A. Pass the main fuse lead through the guide
of the battery box 1.
B. Insert the main fuse until it is completely
over the tab projection of the battery box 2.
C. Put the anti-theft alarm lead coupler in
front of the dividing rib of the battery box 2.
D. Route the tail/brake light lead through the
left of the battery box 2 boss.
E. After passing the tail/brake light lead,
license plate light lead, right turn signal
light lead and left turn signal light lead
through the guide of the battery box 2,
route them between the ribs.
F. When installing the seal, align it to the
push pin trace mark of the rear frame (both
left & right).
G. Align the positioning tape of the battery
negative lead to the clamp.
H. Face the excess end of the clamp to inside
and the end should not be above the tool
reception bearing surface of the battery
box 1.
I. Align the positioning tape of the starter
motor lead to the clamp.
J. Up/down position of the battery negative
lead and starter motor lead is shown in the
illustration.
K. Install the battery positive lead (red) on top.
L. Insert the fuse box until back of the tab of
the battery box 2.
M. Installing direction of the tool is insignifi-
cant.
N. Install the main harness with its tab fitted
inside of the battery box 1.
2-68
CABLE ROUTING