Brightness Control Mode - Yamaha Star XV19CTSX Owner's Manual

1. Push the "SELECT" switch to
change the display to the clock
mode.
2. Push the "SELECT" and reset
switches together for at least two
seconds.
3. When the hour digits start flashing,
push the reset switch to set the
hours.
4. Push the "SELECT" switch, and
the minute digits will start flashing.
5. Push the reset switch to set the
minutes.
6. Push the "SELECT" switch and
then release it to start the clock.
Self-diagnosis device
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If any of those circuits are defective, the
engine trouble warning light will come
on, and then the odometer/tripme-
ter/clock display will indicate a two-digit
error code.
If the odometer/tripmeter/clock display
indicates any error codes, note the
code number, and then have a Yamaha
dealer check the vehicle.
INSTRUMENT AND CONTROL FUNCTIONS
CAUTION:
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.

Brightness control mode

1. Multi-function meter unit panel
2. LCD
3. Speedometer needle
4. Tachometer needle
5. Fuel gauge needle
The brightness can be adjusted for the
following:
G the multi-function meter unit panel
(item number "1")
G
the LCD (item number "2")
3-6
G
ECA11590 the speedometer, tachometer, and
the fuel gauge needles (item num-
ber "3")
Select the brightness control mode as
follows.
1. Turn the key to "OFF".
2. Push and hold the "SELECT"
switch.
3. Turn the key to "ON", and then re-
lease the "SELECT" switch after
five seconds.
Item number "1" is displayed.
1. Multi-function meter unit panel
2. Item number
3. Brightness level
4. Adjust the multi-function meter unit
panel brightness level by pushing
the reset switch.
3