Yamaha 2009 YZF-R1 (Y) Service Manual page 109

1. Upper air filter case
2. Fuel hose (secondary injector fuel rail side)
3. Fuel hose (primary injector fuel rail side)
4. Primary injector fuel rail
5. Secondary injector sub-wire harness
6. Throttle cable (pull side)
7. Throttle cable (return side)
8. Black coating
9. White coating
10.Intake air pressure sensor
11.Accelerator position sensor
12.Plastic locking tie
13.Primary injector sub-wire harness
14.Fuel damper
15.Primary injector #1 coupler
16.Primary injector #2 coupler
17.Primary injector #3 coupler
18.Primary injector #4 coupler
19.Cap
A. Checker color: orange
B. Checker color: black
C. Rotate the clip to the right of the vehicle.
D. Adjust top edge of the clip to top edge of
the paint.
E. Make sure the intake air pressure sensor is
touching against the stopper and install it
horizontally.
F. After installing the intake air pressure sen-
sor, do not press it to the direction of the
arrow.
G. Clamp the primary injector sub-wire har-
ness at the position shown in the illustra-
tion.
H. A cap for synchronization
I. 30°
J. Mass of plastic locking ties
K. Mass of plastic locking ties should be
within this range.
2-72
CABLE ROUTING