Brightness Control Mode - Yamaha Star XV19SY Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
2. Push the "SELECT" and reset
switches together for at least two
seconds.
3. When the hour digits start flashing,
push the reset switch to set the
hours.
4. Push the "SELECT" switch, and
the minute digits will start flashing.
5. Push the reset switch to set the
minutes.
6. Push the "SELECT" switch and
4
then release it to start the clock.
Self-diagnosis device
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If a problem is detected in any of those
circuits, the engine trouble warning light
will come on or flash, and then the
odometer/tripmeter/clock display will
indicate a two-digit error code.
If the odometer/tripmeter/clock display
indicates any error codes, note the
code number, and then have a Yamaha
dealer check the vehicle.
NOTICE
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.

Brightness control mode

1. Multi-function meter unit panel
2. LCD
3. Speedometer needle
4. Tachometer needle
5. Fuel gauge needle
The brightness can be adjusted for the
following:
G the multi-function meter unit panel
(item number "1")
G
the LCD (item number "2")
4-6
G
ECA11590 the speedometer, tachometer, and
the fuel gauge needles (item num-
ber "3")
Select the brightness control mode as
follows.
1. Turn the key to "OFF".
2. Push and hold the "SELECT"
switch.
3. Turn the key to "ON", and then re-
lease the "SELECT" switch after
five seconds.
Item number "1" is displayed.
1. Multi-function meter unit panel
2. Item number
3. Brightness level
4. Adjust the multi-function meter unit
panel brightness level by pushing
the reset switch.