To Set Clock; Brightness Control Mode - Yamaha STRATOLINER XV19CTSC Owner's Manual

To set the clock:
1. Push the "SELECT" switch to
change the display to the clock
mode.
2. Push the "SELECT" and "RESET"
switches together for at least two
seconds.
3. When the hour digits start flashing,
push the "RESET" switch to set the
hours.
4. Push the "SELECT" switch, and
the minute digits will start flashing.
5. Push the "RESET" switch to set
the minutes.
6. Push the "SELECT" switch and
then release it to start the clock.
Self-diagnosis devices
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If any of those circuits are defective, the
engine trouble warning light will come
on, and then the odometer/tripme-
ter/clock display will indicate a two-digit
error code (e.g., 12, 13, 14).
INSTRUMENT AND CONTROL FUNCTIONS
If the odometer/tripmeter/clock display
indicates any error codes, note the
code number, and then have a Yamaha
dealer check the vehicle.
CAUTION:
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.

Brightness control mode

1. Multi-function meter unit panel
2. LCD
3. Speedometer needle
4. Tachometer needle
5. Fuel gauge needle
The brightness can be adjusted for the
following:
3-6
G
the multi-function meter unit panel
(item number "1")
G the LCD (item number "2")
G the speedometer, tachometer, and
the fuel gauge needles (item num-
ECA11590
ber "3")
Select the brightness control mode as
follows.
1. Turn the key to "OFF".
2. Push and hold the "SELECT"
switch.
3. Turn the key to "ON", and then re-
lease the "SELECT" switch after
five seconds.
Item number "1" is displayed.
1. Multi-function meter unit panel
2. Item number
3. Brightness level
3