Yamaha 2009 YZF-R1 (Y) Service Manual page 89

1. Clutch cable
2. Main switch lead
3. Left handlebar switch lead
4. Steering damper lead
5. Horn lead
6. Horn
7. Brake hose
8. Front brake light switch lead
9. Throttle cable (decelerator cable)
10.Throttle cable (accelerator cable)
11.Right handlebar switch lead
12.Throttle cable
13.Steering damper bracket
14.Lower bracket
A. After passing the clutch cable through the
clutch cable guide, route it along and front
of the main switch.
B. Make sure the main switch lead is not tight
when turning the handle to the right of the
stopper.
C. Route the clutch switch lead outside of the
left handlebar switch lead.
D. Fasten the brake hose with the outer tube
of the front fork.
E. The clamp should be above the front brake
hose. The throttle cable (decelerator cable)
should be on the bottom and the throttle
cable (accelerator cable) should be above.
Fit the clamp toward outside rather than
inside.
F. 30–60 mm (1.18–2.36 in)
G. Route the front brake light switch lead
under the brake hose.
H. Route the right handlebar switch lead
above the metal fitting on the brake hose.
I. Route the throttle cable above the under
bracket, inside of the front fork and under
the brake fluid reservoir hose.
J. Clamp the horn lead back and inside of the
lower bracket projection.
K. Lower bracket projection
L. Face the end of the plastic band to the left
and cut off the excess end leaving 2–4 mm
(0.08–0.16 in).
M. Outside of the vehicle.
N. Inside of the vehicle.
O. 0–25 mm (0–0.98 in)
P. Face the end of the clamp to front of the
vehicle and the bundle should be within the
area shown in the illustration. Fasten the
clamp until at least two lines are visible.
2-52
CABLE ROUTING