Belling PBi60R User & Installation Instructions Manual page 24

Recessed Method (selected models)
Recess the work top to the appropriate depth and
shape to fit the hob.
Apply the self adhesive seal to the underside of the
hob glass. For best results, the seal should be
adhered along each joint in turn, as close to the
edge as possible, and trimmed at each corner, tak-
ing care to ensure a neat join.
Insert the hob into the recess, ensuring that the
foam seal is sitting correctly. Locate and attach the
securing clamps to the front and rear underside of
the hob, using the screws provided. Tighten the
screws so that the hob is pulled down firmly against
the worktop, thus ensuring a good seal.
You may want to fill any gap between the hob top
glass and the work top surface with silicone sealant.
DO NOT fit silicone sealant under the glass hob
instead of foam seal.
Installation Instructions
Metal hob
frame
24
Important: Clamps may
i
be reversed to fit either
30mm or 40mm deep
work top.
Silicone sealant (to be used to fill
gap between the worktop& the glass)
Glass hob
Foam
surface
seal
Worktop
surface