Advertisement
Drive Installation
The top enclosure houses the SOURCE drive and the bottom enclosure
houses the TARGET drive.
To install drives, unlock the enclosure using the provided key and gently pull
the lever until the door swings open.
For 3.5" installation, insert the drive with the SATA connectors to the rear and
the label side up as shown. For 2.5" drives, follow the steps below to install
the drive in the Snap-In 25 adapter, then insert into the enclosure with the
SATA connectors to the rear and the "Addonics" side up as shown. Lock the
enclosure with the provided key - the drive will not power up until the enclo-
sure is locked.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Advertisement
