CyberData 011186 Operation Manual page 37

Web Page Item
Auto-Answer Incoming Calls
Button Lit When Idle
Button Brightness (0-255)
Play Ringback Tone
Enable Push to Talk
Disable HTTPS (NOT recommended)
Operations Guide
Table 2-7. Device Configuration Parameters (continued)
Description
When selected, the device will automatically answer
incoming calls. When Auto-Answer Incoming Calls is
disabled, the device will play a ring tone (corresponds to
Ring Tone on the Audiofiles page) out of the speaker until
someone presses the Call button to answer the call or the
caller disconnects before the call can be answered.
When selected, the Call button LED is illuminated while
the device is idle (a call is not in progress).
The desired Call button LED brightness level. Acceptable
values are 0-255, where 0 is the dimmest and 255 is the
brightest. Enter up to three digits.
When selected, the device will play a ringback tone
(corresponds to Ringback Tone on the Audiofiles page)
out of the speaker while placing an outbound call. The
Ringback Tone will play until the call is answered.
This option is for noisy environments. When enabled, the
microphone will be muted normally. When the Call button
is pressed and held, it will unmute the microphone and
allow the operator to send audio back. Using Push to Talk
prevents the operator from terminating a call by pressing
the Call button. The call must be terminated by the phone
user.
Disables the encrypted connection to the webpage. We do
not recommend disabling HTTPS for security reasons.
Click on the Test Audio button to do an audio test. When
the Test Audio button is pressed, you will hear a voice
message for testing the device audio quality and volume.
Click on the Test Microphone button to do a microphone
test. When the Test Microphone button is pressed, the
following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the Test Relay button to do a relay test.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
930796L
Installing the VoIP Outdoor Intercom
Intercom Setup
CyberData Corporation
30