Camera Setup For Network Connection; Connecting Via Wireless Lan - JVC GY-HM660U Instruction

Camera Setup for Network Connection

1 Connect an appropriate adapter according
to the intended use to the [HOST] terminal
at the rear of the camera recorder.
The following adapters can be connected.
Wireless LAN adapter
0
Ethernet adapter
0
Cellular adapter
0
HOST
Connect an appropriate adapter
.
Memo :
Only a network connection adapter can be
0
connected to the [HOST] terminal.
Connect or disconnect an adapter only after you
0
have turned off the power of the camera
recorder.
You can find the latest information on the
0
compatible adapters at the product page of our
website.
Two types of network coverage (WAN and LAN)
0
are available for each application.
2 Enable the network connection.
Set [Main Menu] B [System] B [Network] to
"On(HDMI Off)" or "On(SDI Off)".
3 Configure the connection settings.
Select [Main Menu] B [System] B [Network]/
0
[Settings] B [Connection Setup] B [Wizard]
and press the Set button (R).
A wizard screen appears according to the
0
type of adapter connected. Follow the
instructions on the screen to perform setting.
(A P150 [Connecting via Wireless LAN] )
(A P152 [Connecting via Wired LAN] )
(A P152 [Connecting via Cellular Adapter] )
150

Connecting via Wireless LAN

Connection via Access Point
1 Perform setting on the camera recorder,
and start up the [Wizard] screen.
(A P150 [Camera Setup for Network
Connection] )
2 [Wireless LAN] appears on the [Wizard]
screen.
.
3 Press the I button to display the [Select
Connection Type] screen.
Select "Connect with Access Point".
Follow the screen instructions to complete
setting. Perform setting for the following.
Mode of connection
0
Method of setting
0
* SSID, type of encryption, Passphrase, and
IP Address setting ("DHCP" or "Manual") in
cases other than WPS
.
4 Setting is complete.
After setting is complete, you can access the
camera recorder via a web browser.
(A P158 [Connecting from a Web Browser
a] )
3