Audio Set Item - JVC GY-HM660U Instruction

9 HDMI TC
For setting whether to superimpose time code to
the [HDMI] terminal.
[Setting Values: On, ROff]
Memo :
When [Main Menu] B [A/V Set] B [Video Set] B
0
[HDMI/SDI Out] is set to "SDI", [HDMI TC] is
fixed at "Off" and cannot be selected.
Set to "Off" if connecting to a device that does
0
not support HDMI TC.
SD Aspect
For setting the style of displaying down-converted
images on a 4:3 aspect ratio screen.
Side Cut:
0
Displays image with the left and right sides cut
off.
Letter:
0
Displays as a wide image with the top and
bottom blackened.
Squeeze:
0
Displays image that is squeezed horizontally.
[Setting Values: Side Cut, Letter, RSqueeze]
Memo :
When [Record Format] B [System] is set to "SD"
0
or "HD+SD", and when [SD Aspect] is set to "4:3",
this item appears as "---" and cannot be selected.
(A P117 [ System ] )
SD Set Up
For selecting whether to add a setup signal to the
video signal output from the [AV] output terminal.
Setup signals are added when "7.5%" is selected.
[Setting Values: 7.5%, 0.0%]
(Default values: 7.5% (U model), fixed at "0.0%" (E
model))
Memo :
Depending on the menu settings of the camera
0
recorder and the condition of the cable
connected to it, the setup signal setting may be
fixed at "0.0%". "0.0%" is displayed in gray in this
case.

Audio Set Item

Input1 Mic Ref.
For setting the reference input level when the
[INPUT1] selection switch is set to "MIC" or "MIC
+48V".
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB, -32dB]
Input2 Mic Ref.
For setting the reference input level when the
[INPUT2] selection switch is set to "MIC" or "MIC
+48V".
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB, -32dB]
Int. Mic Gain
For setting the sensitivity of the built-in microphone.
[Setting Values: +12dB, +6dB, R0dB]
AUX Gain
For setting the sensitivity of the [AUX] terminal
input.
[Setting Values: +12dB, +6dB, R0dB]
Ref. Level
For setting the audio reference level to be recorded
to the SD card. (Applies to both [CH1/CH2].)
[Setting Values: -12dB, -18dB, R-20dB]
Limiter
For setting the limiter operation.
Ref. Level:
0
Sets "Ref. Level" to the maximum recording
level.
-8dBFS, -5dBFS:
0
Sets "-8dBFS" or "-5dBFS" to the maximum
recording level.
Off:
0
Depending on the settings of the [CH1/CH2
AUTO/MANUAL] selection switches, the
operation may be different as described below.
The limiter does not function when
0
"MANUAL" is set.
The limiter functions at -5 dBFS when
0
"AUTO" is set.
[Setting Values: Ref. Level, -8dBFS, R-5dBFS, Off]
AGC Response
9 Attack Time
Sets the time to activate the limiter.
[Setting Values: Fast, RMiddle, Slow]
9 Decay Time
Sets the time to deactivate the limiter operation.
[Setting Values: Fast, RMiddle, Slow]
113