JVC GY-HM660U Instruction page 60

Memo :
Use the cross-shaped button (I) to switch
0
between the Color Temperature Selection
screen and the Color Temperature Detailed
Selection screen.
If [White Balance] has been assigned to the user
0
button, pressing the assigned user button will
display the Color Temperature Selection
screen.
(A P38 [Assignment of Functions to User
Buttons] )
Memory A Mode (A), Memory B Mode
(B)
Set to the white balance saved in Memory A or
0
Memory B.
When the [WHT BAL B/A/PRESET] selection
0
switch is set to "A" or "B", press the [y] button
to execute white balance. The white balance will
be automatically adjusted and the adjusted
value will be saved in Memory A or Memory B.
1 Prepare the camera recorder.
A Set the [POWER ON/OFF(CHG)] switch to "ON".
B Press the [IRIS] button to set to the Auto mode.
C Set the [FULL AUTO] switch to "OFF".
2 Set the [ND FILTER] switch according to the
lighting.
(A P58 [Setting the ND Filter] )
3 Set the [WHT BAL B/A/PRESET] selection
switch to "A" or "B".
4 Locate a place with similar lighting conditions
as the object to be shot, place a white object
near the center of the screen and zoom in to
fill the screen with white.
5 Press the [y] (Auto White Balance) button.
The white detection frame appears when Auto
0
White Balance is activated. Fill the frame with
white completely.
While Auto White Balance is starting up,
0
"A< y >" or "B< y >" appears on the screen.
(y mark appears blinking)
After the correct white balance is obtained, an
0
estimated value of the current color
temperature is displayed.
60
282min
100min
50min
1920x1080
60 i HQ
4030 20 10 0
A
[AWB] Activating
282min
100min
50min
1920x1080
60 i HQ
4030 20 10 0
A 3700K
Result Display
.
Caution :
Do not use highly reflective objects, such as
0
metals. Doing so may result in improper white
balance adjustment.
The Auto White Balance function cannot provide
0
optimum white balance with an object outside the
adjustment range, for example when it contains
only a single color or not enough white color.
Error Message
If the Auto White Balance adjustment is not
correctly completed, one of the following
messages will appear for about 3 seconds.
Message
Auto White * NG: Displayed when there is not
Object enough white color on the
(*A or B) object, or when the color
temperature is not suitable.
Use another white object and
adjust the white balance
again.
Auto White * Error: Displayed when the lighting is
Low Light dark. Increase the lighting
(*A or B) and adjust the white balance
again.
Auto White * Error: Excessive illumination.
Over Light Displayed when the lighting is
(*A or B) too bright. Decrease the
lighting and adjust the white
balance again.
00: 00: 00.00
Jan 12,2016
12 :34 :56
White Detection
5 . 6f t
Frame
ND 1 /64
AE 6
+
0
dB
F1. 6
1/ 100
Blinking
00: 00: 00.00
Jan 12,2016
12 :34 :56
5 . 6f t
ND 1 /64
AE 6
+
0
dB
F1. 6
1/ 100
Status