JVC GY-HM660U Instruction page 81

Press [REC] Press [REC]
(Recording starts) (Recording resumes)
Press [REC]
(Recording pauses) (Recording pauses)
Recording 1 Recording 2
Completed Clip
(Recorded video and audio)
Recording 1 Recording 2
.
1 Set "Rec Mode" to "Clip Continuous".
(A P120 [ Rec Mode ] )
Set [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] to "Clip Continuous".
The display changes ("STBY" B "STBYC").
0
2 Start recording. (Recording 1)
Press the [REC] button to start recording in
0
Clip Continuous mode.
The display changes ("STBYC" B
0
"RRECC") and the card slot status indicator
lights up in red.
3 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECC"
B "STBYC" (yellow text)).
The card slot status indicator remains lighted
0
in red.
Memo :
When the [CANCEL] button is pressed while the
0
camera recorder is paused (STBYC), the
display changes ("STBYC" (yellow text) B
"STBYC" (blinking yellow text) B "STBYC"
(white text)), and a "clip" is generated. The card
slot status indicator lights up in green.
4 Resume recording. (Recording 2)
Press the [REC] button again to resume
0
recording. The display changes ("STBYC"
(yellow text) B "RRECC").
The card slot status indicator remains lighted
0
in red.
Press [REC]
(Recording resumes)
Press [REC] Press and hold [REC]
(Recording stops)
Recording 3
Recording 3
5 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECC"
B "STBYC" (yellow text)).
The card slot status indicator remains lighted
0
in red.
6 Resume recording. (Recording 3)
Press the [REC] button again to resume
0
recording. The display changes ("STBYC"
(yellow text) B "RRECC").
The card slot status indicator remains lighted
0
in red.
7 Press and hold the [REC] button.
Recording stops and the display changes
0
("RRECC" B "STBYC"). A "clip" is
generated.
The card slot status indicator lights up in
0
green.
8 Press the [REC] button again.
The display changes ("STBYC" B
0
"RRECC") and the card slot status indicator
lights up in red.
A new "clip" is generated from here.
0
Memo :
The following operations cannot be performed
0
while recording is paused (STBYC, yellow text).
Clip Review operation
0
(A P74 [Viewing Recorded Videos Immediately
(Clip Review)] )
Switching SD card slots
0
Switching operation mode
0
(A P18 [Operation Modes] )
Caution :
Do not remove the SD card during recording
0
(RRECC, red text) or recording pause
(STBYC, yellow text).
To remove the SD card in the "Clip
0
Continuous" mode, press the [CANCEL] button,
check that "STBYC" (white text) is displayed
and the card slot status indicator lights up in
green before you remove the card.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
When the [POWER ON/OFF(CHG)] switch is
0
turned off during recording or recording pause,
recording stops and power is cut off after a clip
is generated.
81