Appendices
Troubleshooting
Power
Symptom
Cause
The unit does not
The unit is not connected to AC
power on when
power.
you press the 1
(on/standby)
button.
All of the LED
A system error occurred.
indicators on the
front panel are
blinking.
Shooting
Symptom
Cause
No picture is
The camera head and CCU are not
output from the
securely connected.
camera.
The [System] menu's [Region] option
setting differs from your video
monitor settings.
Camera picture
The camera head and CCU are not
output is distorted
securely connected.
(does not display
properly).
Solution
Connect AC Power.
Remove the power cord and check the camera cable and
connection with other devices.
If the problem persists, contact Sony service representative.
Solution
Check the connection with the camera head.
Correctly set the [System] menu's [Region] setting (see
page 43).
You can also change the [Region] setting as follows.
To set to [NTSC]: Press the 1 (on/standby) button to set
the unit to standby mode while holding down the
MENU and V buttons.
To set to [PAL]: Press the 1 (on/standby) button to set the
unit to standby mode while holding down the MENU
and v buttons.
Check the camera cable connection. Insert the camera
cable's connector fully, and turn the connector ring to
secure it.
Troubleshooting
49