Limit Position And Cut Down Position Initialize - Roland SP-300 Service Manual Book

4 Adjustment
4-5 LIMIT POSITION & CUT DOWN POSITION INITIALIZE (Referential Time : 10min.)
[About LIMIT POSITION & CUT DOWN POSITION INITIALIZE]
This is used to detect the distance between the Limit Sensor and the Capping Position. After completing the
detection, the distance from the Cut Down Position to the Limit Sensor will be detected. When the Limit
Position is not correctly set, locking problem could occur.
4
Remove the I/S COVER.
1
Turn on the SUB POWER SW while pressing [ ], [ ]
2
and [ ] keys.
Connect the Tool carriage and Head carriage.
3
Push the HEAD CARRIAGE leftward and check if it is
locked.
If it is locked, proceed to the next step.
If it is not locked, move the HEAD CARRIAGE
rightward until it will be locked.
After the HEAD CARRIAGE is locked, push the
Head Carriage to the left until it stops because there
is a play with the HEAD CARRIAGE.
4-26
[ ] , [ ] , [ ] + POWER ON
LIMIT INITIALIZE
MENU
MOVE TO CAP POS
I/S COVER