Adjusting Valve Clearance And Retightening The Cylinder Head Bolts - Whisper Power M-SC6 User Manual

5.4.2 Adjusting valve clearance and
retightening the cylinder head bolts.
Both procedures have to be carried out with a cold engine.
When both procedures are carried out be sure to retighten
the cylinder head bolts before adjusting the valve
clearance. When retightening the cylinder head bolts,
drain the coolant by removing the drain plug (ref. to fig. 2).
Loosen the bolts slightly, remove the rocker assembly (the
rocker arms, shaft, and stays) and then retighten the bolts
to the specified torque in the numerical order illustrated
(ref. to fig. 23).
6
3
5
8
4
7
2
1
Fig. 23a
M-SC6/8
Tightening torque:
Rocker stay tightening torque:
The clearance of both (intake and exhaust) valves should
be 0.25 mm in cold condition.
1 Set the piston of the first cylinder to be adjusted to top
dead centre (T.D.C.) of compression stroke.
2 The T.D.C. of compression stroke can be found by
aligning the T.D.C. mark (notch) on the crankshaft
pulley with the mark on the gear case (ref. to fig. 24).
1
Fig. 24a:
2 cylinder engine
3 First align the T.D.C. mark for the No. 1 cylinder.
Confirm that the valves do not move up or down when
the crankshaft is turned about 20 degrees in normal
and reverse direction of rotation. If the rocker arms
move piston no.1 is on the T.D.C. of the intake or
exhaust stroke. In such case turn the crankshaft 360°
EN / M-SC6/8/10 / December 2010
11 7 5
8
9 4 6
2 1 3
Fig. 23b
M-SC10
M10 bolt 75-85 Nm
M8 bolt 20-30 Nm
M8 bolt 15-22 Nm
2
1
Fig. 24b:
3 cylinder engine
in the direction of engine rotation again. No. 1 piston
is now at T.D.C. of the compression stroke.
4 To adjust the valve clearance of the No. 2 and No.3
cylinder
a. Two cylinder engine (M-SC6 and 8): the
crankshaft pulley has to be turned 180 degrees
clockwise
Adjustment can be executed.
b. Three cylinder engine (M-SC10): After adjusting
the valves of cylinder 1 turn the crankshaft 240
degrees clockwise from the T.D.C of cylinder 1
to the T.D.C of cylinder 3. Position 2 fig. 24b
against the notch. Adjust the valves of cylinder
3. Then turn the crankshaft 240 degrees further
clockwise to the T.D.C of cylinder 2 and adjust
10
the valves; position 3 fig. 24b against the notch.
Check after each adjustment that the valves do not move
up and down when turning the crank craft about 20
degrees clockwise and counter clockwise of T.D.C.
2
3
TROUBLE SHOOTING
to set this piston to T.D.C.
35