Warnings; Service Address - Whisper Power M-SC6 User Manual

TROUBLE SHOOTING
PROBLEM
Over-temperature
5.2.3

Warnings

Generator must be shut off immediately if:
● Motor RPM suddenly rises or drops.
● Unusual noise comes from generating set.
● Exhaust gases suddenly colour dark.
● Engine failure warning light is on
32
CAUSE
• Wear out of cylinder.
• Overload.
• Low level of cooling oil or air in the
cooling system
• Water inlet system blocked.
• Broken impeller.
• Water strainer choked
• Heat exchanger choked.
• Broken or slipping V-belt.
• Faulty thermostat
SOLUTION
Have the compression measured and have the
engine overhauled.
Take away the overload.
Fill up with liquid and release air bubbles.
Check if there are air blocks in the system;
refer to the installation manual
Check the cooling system thoroughly.
Replace and adjust the V-belt tension.
Check the thermostat or replace.
5.2.4

Service address

If you cannot correct a problem with the aid of the mal-
function table, contact your WhisperPower Service Centre
or WhisperPower Netherlands, tel: INT+31-512-571550.
www.whisperpower.eu.
December 2010 / M-SC6/8/10 / EN