Recommendations; Ventilation; Chimney Versions; Forced Flue Versions - DeDietrich Elidens DTG130-45 User Manual

1.2 Recommendations

For a proper operating of the boiler, follow
carefully the instructions.
Any intervention on the appliance and heating
equipment must be carried out by a qualified
engineer.
The manufacturer is not liable for any improper
use of the appliance or failure to maintain or
install the unit correctly (the user shall take care
to ensure that the system is installed by a
qualified engineer).

1.3 Ventilation

1.3.1

Chimney versions

Do not obstruct the air inlets in the room (even
partially).
France: the cross section of the aeration vent, which is
compulsory in the boiler room in which the boiler is
installed, must comply with the DTU 61.1 (P 45 204)
standard and, in particular, with the instruction on boiler
room layout (Book 1764 April 1982).
Belgium:the cross-section of the aeration vents, which
are compulsory in the room in which the boiler is installed,
must comply with the NBN D51-003 standard.
1.3.2

Forced flue versions

It is not necessary to provide ventilation of the premises
in which the boiler is installed. Ventilation is required if a
mechanical connection to the gas exists.

1.4 Maintenance

- The servicing and cleaning of the boiler and the
sweeping of the flue gas pipe and the bleed pot must be
done at least once a year by a qualified professional.
- Regularly check the level of water in the system and top
up if required, taking care that cold water is not added
suddenly into the boiler when it is hot.

1.5 Adapting to another gas type

Belgium:
The operations required to switch from one gas to another
must be carried out by a SERV'elite technician.
4
Check the seal on the gas and water pipe
connections.
Check that the appliance is properly set for the
type of gas used.
Keep to the polarity shown on the terminals:
phase (L), neutral (N) and earth
Check regularly that the installation contains
water and is pressurised.
Burn hazard in direct contact with the flame
inspection window.
Germany: the cross section of the ventiliation vents,
which are compulsory in the room in which the boiler is
installed, must comply with the VDI 2050 form 1 standard
and with other prevailing regulations.
Other countries: the cross section of the aeration inlet,
which is compulsory in the premises in which the boiler is
installed, must comply with the standards in force in the
country.
- We recommend taking out a maintenance contract.
Do not drain the installation, except in cases of
absolute necessity. For example: Several
months' absence with the risk of ice in the
building.
Other countries:
The operations required to switch from one gas to another
must be carried out by your fitter.
DTG130 - 45/65/90/115 Eco.NOx Plus
.
18/06/2015 - 300005222-02