TRIMMING
An agent has proceed to the first adjustments and cable tension. After few trips you will
have to do the final adjustment to obtain a correct rectitude in transversal; it is also
important to keep the mast rectilinear in longitudinal when sailing.
Therefore, it needs compensation adjustment along side; a first bending of the mast in
longitudinal is required : the middle of the mast bended forward and the head afterward.
The bend must be the half of the mast section.
1 - This is a pushing spreader rigging, so you will have to stretch the upper shrouds befo-
re the backstay.
2 - Stretch tighly all the rigging ( the rigging must be a little bit loosely when sailing with
15-20 knots).
3 - When a perfect transversal and longitudinal rectitude has been obtained, ease t h e
both side aft lower shrouds with 2 turns of bottlescrew.
4 - Finish longitudinal adjustment by stretching tightlier the backstay bottlescrew to
obtain a good stability of the forestay when sailing by 15-20 knots.
Fasten with pins all the bottlescrews and keep this trimming during all the sailing sea-
son.
COMPENSATION ADJUSTMENT:
Ease the backstay during the wintering.
index 1
5
25
58