MUTOH ValueJet VJ-1204 Quick Reference page 93

No.
3 Does the media bend?
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
No.
1 Is the loading position of the media
correct?
2 Did you set up the origin and print
position?
(3) Printing is blurred
No.
1 Are you using the recommended
media?
2 Are you using the thick or thin media? Use the recommended media.
3 Is the media printed on the printing
surface?
4 Did you perform Alignment?
5 Did you perform Media feed
compensation?
6 Is each heater set to the appropriate
temperature?
7 Is the head height set to High?
(4) White or black lines appear on printed media
No.
1 Are you using the recommended
media?
2 Is the scroller set correctly?
3 Is the nozzle in good condition?
4 Did you perform Alignment?
5 Troubleshooting
Possible cause
Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
Possible cause
Set the media correctly.
Cancel or reset the settings of the origin and
print position.
Possible cause
Use the recommended media.
Confirm the printing surface of the media
and set it correctly.
Perform Alignment.
Perform Media feed compensation.
Set it to the appropriate temperature.
Return the head height to "Normal (Low)".
Possible cause
Use the recommended media.
Set the scroller correctly.
Perform Head cleaning.
Perform Alignment.
VJ-1204 QUICK REFERENCE
Remedy
type" in the Operation
Manual
menu" in the
Operation Manual
Remedy
media
menu" in the
Operation Manual
Remedy
type" in the Operation
Manual
type" in the Operation
Manual
print head
feed compensation" in
the Operation Manual
menu" in the
Operation Manual
height adjustment" in
the Operation Manual
Remedy
type" in the Operation
Manual
media
cleaning
print head
Reference
"4.2.1 Media
"5 Panel setup
Reference
3.5.2 Setting roll
"5 Panel setup
Reference
"4.2.1 Media
"4.2.1 Media
3.5 Setting media
5.1.2 Adjust the
"4.2.6 Media
"5 Panel setup
"4.2.5 Head
Reference
"4.2.1 Media
3.5.1 Loading roll
4.2.3 Head
5.1.2 Adjust the
5-17