Setting Modes: Setting The Outdoor Unit Eeprom; Mode Settings - Panasonic U-26PE1U6 Technical Data & Service Manual

6. Mode Settings

5-12. Setting Modes : Setting the Outdoor
Unit EEPROM
Setting mode 1
<Operating procedure>
Press and hold the
À
(Ventilation) button simultaneously for 4
seconds or longer.
Press the temperature setting
Á
buttons to change the item code. The item codes
and setting data are shown in the table below.
Press the timer time
Â
change the setting data.
To confirm the changed setting data, press the
button.
(At this time, " " display stops blinking
and remains lit.)
During this mode, "
Ã
blinking. The outdoor unit address display section
displays "ALL," the item code and number (DN
value in the table), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The
display changes between the first 3 digits (Fig. A )
and the last 3 digits (Fig. B
When the first 3 digits are displayed, the bottom dot
of the colon is illuminated.)
To exit the setting mode, press the
Ä
button.
(Check) button and
and
buttons to
and
" is displayed,
).
(Check)
Outdoor Unit Maintenance Remote Controller
5. Outdoor unit maintenance remote control
A Display of fi rst 3 digits
Á
A
Â Ä À
B Display of last 3 digits
Á
A
Â Ä À
A and B are displayed alternately.
(Example shows display of 000 001.)
5-21
2WAY SYSTEM
5