Panasonic U-26PE1U6 Technical Data & Service Manual page 107

Loose wiring may cause the terminal to overheat or result in unit malfunction.
A fire hazard may also occur.
WARNING
Therefore, ensure that all wiring is tightly connected.
When connecting each power wire to the terminal, follow the instructions on "How to connect wiring to the terminal" and fasten the
wire securely with the fixing screw of the terminal board.
How to connect wiring to the terminal
For stranded wiring
(1) Cut the wire end with cutting pliers, then strip the insulation
to expose the stranded wiring approx. 3/8 inch (10 mm) and
tightly twist the wire ends. (Fig. 1-3)
(2) Using a Phillips head screwdriver, remove the terminal
screw(s) on the terminal board.
(3) Using a ring connector fastener or pliers, securely clamp
each stripped wire end with a ring pressure terminal.
(4) Place the ring pressure terminal, and replace and tighten
the removed terminal screw using a screwdriver. (Fig. 1-4)
Wiring sample
Type F2
Use this screw when connecting the shield
for the remote control wiring to ground.
Remote Control
Wiring
Power Supply
Inter-unit Control
Wiring
1-99
Stranded wire
Ring
pressure
terminal
Special
Screw
washer
Ring pressure
terminal
Terminal board
Wire
Wire
Band
(supplied)
Rock nut
Power supply
wiring
1. Specifications
Fig. 1-3
Screw and
Special washer
Ring
pressure
terminal
Fig. 1-4
Conduit
(field supply)
1