Panasonic U-26PE1U6 Technical Data & Service Manual page 167

(4) Setting the Flap Separately
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps operate
in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
<Procedure of CZ-RTC2>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
and select the address (unit No.) of the indoor unit
to set. At this time, the fan at the indoor unit begins
operating.
3 " ", unit No. "
group control), item code "
" " are displayed blinking on the remote
controller LCD display.
4 Designate the item code "
Temperature Setting
=91
Flap
, and buttons
button
" (or " " in the case of
", and settings data
" by adjusting the
/ buttons.
Electrical component box
=90
=93
=92
5 Press the timer time
desired setting data.
Flap position
5
* Setting data "
Setting data
Without separate setting
Swing
Move to position
Move to position
Move to position
Move to position
Move to position
When the flap position is set to
in the cooling or dry mode, the flap position is moved to
and the operation is started. (refer to Fig. 1-141)
3
NOTE
The flap swings during the operation under "Setting the
Flap Separately".
At this time, the unselected flaps are moved to the
position 1 . (refer to Fig. 1-141)
6 Press the button.
(The display stops blinking and remains lit, and setting
is completed.)
If you wish to change the selected indoor unit, follow
the step 2.
7 Press the button to return to normal remote
controller display.
7
1
1-159
1. Specifications
/ buttons to select the
1
2
3
4
Fig. 1-141
" (refer to Fig. 1-141)
Flap position during operation
and stay
1
2 and stay
and stay
3
and stay
4
5 and stay
or and the unit is
4 5
3
6 5
1
2
4