Panasonic U-26PE1U6 Technical Data & Service Manual page 190

CZ-RWSU3U
7-12. Supplied Accessories
Wireless Remote
Controller
(1)
7-13. Installing the Receiver
The receiver can only be installed on the corner indicated in Fig. 1-219. Consider how the panel will
face when it is installed on the indoor unit.
1 Remove the air inlet grill.
2 Remove the screw holding the adjustable corner cover. Then slide the cover to the side and remove it. (Fig. 1-220)
1
Box with
indoor unit's
electrical
parts
3 To pass the wire through the panel, bend the part (shaded area) on the square hole and then
pass wire protrudingfrom the wireless receiver through the grill. (Fig. 1-221)
4 After wiring according to the directions in "Wiringfor the Receiver", leave enough wire length so that the
receiver's adjustable corner cover can be removed andfasten the wire with the clamper. (Fig. 1-221)
5 Hang the corner cover string on the pin of the ceiling panel (Fig. 1-222). Then slide the corner cover
onto the ceiling panel until the three clips are correctly located, and then fix it in place with the screws.
Make sure the wire is not caught.
Refer to the installation instructions supplied with the panel.
Bend the part (shaded
area) with a screwdriver
or similar implement to
allow the wire to pass
through.
For more information about wiring and test operation, see the sections on "Wiring for the Receiver" and
"Test Operation"
Supplied Accessories
Remote Control AAA Size
Holder Battery
(1) (2)
Receiver position
Fig. 1-219
Fig. 1-221
Operating Wood Screw
Instructions
(1) (2)
Adjustable corner cover
Screw
Fig. 1-220
Fix it in place
with the
clamper.
Fix the
screw.
Fig. 1-222
1-182
1. Specifications
Clamper
(1)
Ceiling panel
Adjustable corner cover
Pin.
Make sure the three clips on the corner
cover are located over the holes on the
ceiling panel and fix it in place with the
supplied screws.