Installation For Use; Preparation Of Mower - Peco 06131512 Operator's Manual

Section II - INSTALLATION FOR USE

2-1 Preparation Of Mower

PTO Drive Models Only
From the underside of the engine, disconnect the wiring
harness attached to the electric clutch. Remove the bolt
and electric clutch from the mower. Refer to Figure 2-1a.
Figure 2-1a
Remove Bolt
Remove the D-drive spacer using an arbor press or
equivalent. On removal, adjacent bearing OUTER race
must be supported or bearing damage may occur. Refer
to Figure 2-1b.
Figure 2-1b
PRESS
Figure 2-1c
Engine Pulley Installation
The engine pulley assembly must be installed using an
arbor press or equivalent. During installation, opposite
bearing inner race must be supported or bearing
damage may occur. Refer to Figure 2-1c.
Remove D Drive Spacer
PRESS
Upon pressing the engine pulley to the clutch, replace
the completed assembly to the mower's engine shaft to
fasten.
Kohler CV740
Fasten engine pulley assembly number 18 P#(A1109) to
the electric clutch using (1) 7/16"-20 x 4" HHCS
P#(K0359) and (1) 7/16" helical spring lock washer
P#(K0140). Torque the bolt to 55ft./lbs. Refer to Figure
2-1d for reference.
Kawasaki FX801V
Fasten engine pulley assembly number 30 P#(A1209) to
the electric clutch using (1) 7/16"-20 x 4" HHCS
P#(K0359) and (1) 7/16" helical spring lock washer
P#(K0140). Torque the bolt to 55ft./lbs. Refer to Figure
2-1d for reference.
Figure 2-1d
7/16"-20
Hex Bolt
Your collection system framework will mount directly to
the rear frame of the Z900 series mower. First, loosen
and remove the metric hex bolts securing the mower's
engine shroud (2 per side). Once the shroud is removed,
use a flat-head screwdriver to remove the retaining nuts
from the shroud. Next, replace and align the holes in the
shroud to the mower's bumper. Then, remove the larger
metric hex bolt from the mower's bumper (1 per side).
Place the removed bolts aside to be used in the next
step. Refer to Figure 2-1e.
Figure 2-1e
Existing Hardware
To Be Used In The
Next Step. (1) Bolt On
Each Side Of The
Mower Frame
6
Electric Clutch
Engine Pulley
Assembly
Lock Washer
Engine
Shroud
Mower's
Bumper
Remove (2) Metric
Hex Bolts and
Retaining Nuts On
Each Side Of The
Mower Frame