Belt Installation And Adjustment - Peco 06131512 Operator's Manual

2-7 Belt Installation and Adjustment

PTO MODELS ONLY
Loosen the (4) bolts P#(K1191), (2) on each side, that
secure the gear box assembly to the PTO assembly
P#(A1950) (Figure 2-7a and 2-7b).
Figure 2-7a
Loosen Bolts
Figure 2-7b
Loosen Bolts
Loosen the adjustment bolt P#(K0348) until the gear box
assembly is at its far left adjustment (the gear box is
moved toward the mower's engine pulley). Refer to
Figure 2-7c.
Figure 2-7c
Loosen The
Adjustment Bolt
Slide Gear Box
Towards The
Engine Pulley
Connect the belt A56K P#(M0239) from the engine
pulley to the lower gear box pulley (Figure 2-7d).
Figure 2-7d
To tension the drive belt, turn the adjustment bolt
clockwise (Figure 2-7e) until there is 1" of deflection, with
10-11 lbs. of pressure, at the center of the belt between
the engine pulley and the gear box pulley.
Figure 2-7e
Once the correct tension of the belt is achieved, tighten
the (4) bolts that secure the gear box assembly. Refer to
Figures 2-7f and 2-7g. Replace the belt guard and
hardware that was removed in Section
Figure 2-7f
Figure 2-7g
Tighten Bolts
11
Connect Belt
To Both Pulleys
Tighten The Adjustment
Bolt To Tension The Belt
2- 5.
Tighten Bolts