Weight Kit Installation - Peco 06131512 Operator's Manual

2-25 Weight Kit Installation

A custom front counterweight kit must be installed on
your mower before operating the collection system. If
equipped, remove the existing weight from the front
mower frame. Refer to Figure 2-25a.
Attach the weight bracket P#(B0600) to the front frame
of the mower, using the existing mounting holes in the
frame. Secure the weight bracket using (2) 1/2"-13 x 1-
1/4" HHCS P#(K1232) and (2) 1/2"-13 nylon flange
locknuts P#(K2012). Refer to Figure 2-25b for weight
bracket orientation before mounting.
Figure 2-25a
Figure 2-25b
(4) 1/2"-13 Locknuts
NOTE: It is recommended that (2) people install the
weight bar. Using a floor jack or similar device, position
the weight bar P#(B0035) under the weight bracket as
shown in Figure 2-25b. While one person helps to keep
the weight bar in position, the other person will secure
the weight bar to the weight bracket. Use (2) 1/2"-13 u-
bolts and P#(K0331) and (4) 1/2"-13 nylong flange
locknuts P#(K2012) to secure the weight bar.
Remove Existing Front
Weight If Equipped
(2) 1/2"-13 U-Bolts
19
Weight Bracket
Weight Bar