Heatline solaris 24PC Installation, Servicing & User Instructions page 46

Supplied by HeatingSpares247.com
OPERATING THE BOILER
Prior to operating the boiler, check that the
pressure reading, on the LCD panel, lies
between 1 and 2 bar.
Set the boiler's 'Central Heating' and 'Domestic
Hot Water' temperature controls to maximum
by turning fully clockwise and set the external
'Room Thermostat' (if fitted) to maximum. (To
set the
manufacturer's instructions.)
Switch the boiler's functional switch to the
position. The boiler's integral control unit
will now automatically carry out pre-ignition
safety checks before finally igniting the
burner.
The 'Central Heating' and 'Domestic Hot
Water' temperature controls and
Thermostat' can now be set to the desired
temperature settings.
When a demand for heat no longer exists, the
burner will automatically shut down but the
45
green 'Boiler Stand by' indicator will remain
alight.
The boiler will be ready for the next heating
demand.
CLEANING
The boiler casing may be cleaned with a damp
cloth followed by a dry cloth to polish. Do not
use abrasive or solvent cleaners.
room thermostat refer
FURTHER ADVICE
For further information or advice (UK) contact
TM
Heatlin :
Service please call:
Spares please call:
Technical assistance please call: 0870 777 8318
Or by E
to its
www.heatline.co.uk
'Room
Page 46
0870 777 8341
0870 777 8402
mail at our Web
solaris 24PC, 30PC
Site on