Nikon COOLPIX S2 VAA36001 Repair Manual page 28

Note: The O-ring [#048] cannot be reused. Replace it with a new one.
The tightening torque value is set for the screw [#105]. Tighten the screw according to the set torque
value. (The tightening torque affects the waterproof function.)
・ Mount the monitor holder [#263].
・ Set the O-rings [#048] onto the screws [#105]. Then, attach the two screws [#105].
<Tightening torque>
When assembling
newly
Screw [#105] 12cN・m
・ Mount the spacer [#262].
・ Attach the two screws [#110].
Monitor holder [#263]
When reassembling
9cN・m
O-ring [#048]
Screw [#105]
Screw [#105]
O-ring [#048]
Screw [#105]
Note:
In case the part, which is attached with the screw and O-ring,
is replaced, tighten the screw and O-ring by the torque for
assembling.
In the other cases, tighten them by the torque for reassembling.
- A11 ･ S2 -
VAA36001-R.3667.A
Monitor holder [#263]
Screw [#110]
Spacer [#262]