Nikon COOLPIX S2 VAA36001 Repair Manual page 20

・ As holding the button top unit [#239] from above, insert the sections "D" and "F" into the sections "E" and "G" of the
inner front cover unit [#201] respectively.
Button top unit [#239]
Section "D"
・ Fit the O-ring [#048] to the screw [#105] and tighten it.
Note: The tightening torque value is set for the screw [#105]. Tighten the screw according to the set torque
value. (The tightening torque affects the waterproof function.)
The O-ring [#048] cannot be reused. Replace it with a new one.
Screw [#105]
O-ring [#048]
OK
※ The metal plate hole must be fit to
the screw hole.
Push it.
Section "E"
Screw [#105]
NG
- A3･ S2 -
Inner front cover unit [#201]
<Tightening torque>
When assembling
newly
Screw [#105] 12cN・m
Note:
In case the part, which is attached with the screw and O-ring,
is replaced, tighten the screw and O-ring by the torque for
assembling.
In the other cases, tighten them by the torque for reassembling.
VAA36001-R.3667.A
Section "F"
Section "G"
When reassembling
12cN・m