Attaching The Analyzer Slider; Attaching The Objectives - Nikon ECLIPSE E200 POL Instructions Manual

Eyepieces
Use the eyepieces with the same magnification for
both eyes. On the right sleeve, attach the eyepiece
with crosshairs. Insert the eyepiece into the sleeve
matching the grooves on the eyepiece with the
positioning projections on the sleeve.
If you have the rubber eye guards (options), set
them on the eyepieces so that they fit on the
grooves at the rim of the eyepieces.
Your eyepiece tube may not have the positioning
pins, positioning projections or rubber eye guards.
5

Attaching the Analyzer Slider

Rotate and remove the stopper screw at the end of
the slider opposite of the rotation ring. Insert the
slider into the intermediate tube from the right
side. Return the stopper screw to the slider.
Usually, the rotation ring is placed on the right side
of the microscope. If the slider is inserted from the
left side, the rotation ring can be set on the left
side of the microscope but it may become a little
difficult to read out the rotation angle of the
analyzer.
6

Attaching the Objectives

Remove the specimen from the stage and fully
lower the stage.
The objective of the highest magnification is to be
screwed on to the hole marked with the circle
sticker (standard screw hole marking). Attach the
remaining objectives in an order that when the
nosepiece is turned clockwise when seen from
above, the magnification of the objective increases.
Whenever attaching or removing the objective, be
sure to remove the specimen, lower the stage and
use both hands so that it may not drop.
VI Assembly
1 Assembly
37
Positioning pin
Positioning pins
Stopper screw
VI