Appliance Setup; Fixed Glass Assembly - Heat & Glo LUX42 Installation Manual

11 11

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
WARNING! Risk of Injury! Glass assembly installation
and removal must be performed by a qualifi ed service
technician. See chart below for glass assembly weights.
LUX42 MODELS: It is recommended that Glass in-
stallation and removal be performed by two qualifi ed
service technicians.
Glass Weights
LUX36
32 lbs
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
Removing Fixed Glass Assembly
This fi xed glass assembly is held in place by side and bot-
tom glass clips and top retaining rail. To remove clips, en-
gage the spring clips with the tool and pull tool out slightly.
Rotate wrist left and right to disengage clip. See Figure
11.1 to understand function of this tool.
1. Glass clip removal/installation tool is fastened to the
lower right corner of the fi replace. Remove tool by
removing one screw. See Figure 11.1. If glass clip re-
moval tool becomes misplaced, a cotter pin removal
tool may be used. Replace glass clip removal/instal-
lation tool in same place with the one screw after use.
Figure 11.1 Fixed Glass Assembly
Figure 11.1. Glass Clip Tool
46
LUX42
41 lbs
Heat & Glo • LUX36, LUX42 Installation Manual
Figure 11.2 Glass Clip Tool Location
2. To disengage bottom glass clips, position the glass
clip removal/installation tool parallel to the fl oor and
insert it about two inches into the gap between the
glass frame and the front bottom fi replace lip. Insert
the tool on the lower left side of the glass clip and
move to the right to engage the clip.
45 degrees and pull the tool out slightly. Then push
downward to disengage the bottom spring clip. Re-
peat for the other two or three bottom spring clips. See
Figure 11.2.
Figure 11.3 Inserting Glass Clip Tool
3. Disengage the left and right glass clips one at a time
using the glass clip removal/installation tool. Insert
tool from the top side of the side glass clip. Pull the
glass tool out slightly to disengage the side clip.
4. Grasp the left and right sides of the glass assembly
and carefully pull outward to remove the bottom from
the three support tabs on the bottom glass clips. Low-
er the glass to remove it from the top retainer rail.
CAUTION! Risk of Injury! DO NOT put fi ngers under
glass frame. Fingers may get pinched by glass frame dur-
ing removal.
• 2287-980 Rev. L • 4/16 • 2287-980 Rev. L
Lift up to about