Heat & Glo LUX42 Installation Manual page 38

NOTICE: DO NOT wire 110-120
VAC to wall switch.
Romex
Connector
14/2WG
GRN wire
inside box
Copper ground
attached to GRN
screw with GRN wire
Figure 8.2 Junction Box Detail
Accessories Requirements
• This appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
• Hearth & Home Technologies recommends that Intel-
liFire TM Plus wireless controls be used for their features
and functionality with the IntelliFire
tem.
Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
38
Plus ignition sys-
TM
Heat & Glo • LUX36, LUX42 Installation Manual • 2287-980 Rev. L • 4/16 • 2287-980 Rev. L