FAAC S418 User Manual
  1. Manuals
  2. Brands
  3. FAAC Manuals
  4. Gate Opener
  5. Safe Zone S418
  6. User manual
FAAC S418 User Manual

FAAC S418 User Manual

Automated system
Hide thumbs Also See for S418:

Advertisement

Table of Contents

See also: Instruction Manual , User Manual
S418
S418

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S418 and is the answer not in the manual?

Questions and answers

Related Manuals for FAAC S418

Summary of Contents for FAAC S418

  • Page 1 S418 S418...
  • Page 2 FAAC a source of danger. FAAC declines all liability caused by improper use or use other than that are used. for which the automated system was intended.

  • Page 3: Table Of Contents

    INDEX 1. DESCRIPTION page.9 1.1. DIMENSIONS page.9 2. TECHNICAL SPECIFICATIONS page.10 3. INSTALLATION page.10 3.1. ELECTRICAL PREPARATIONS (standard system) page.10 3.2. PRELIMINARY CHECKS page.10 3.3. INSTALLATION VALUES page.10 3.4. INSTALLATION OF THE OPERATORS page.11 3.5. WIRING THE OPERATOR page.12 3.6. MECHANICAL STOPS page.12 4.

  • Page 4: Description

    S418 AUTOMATED SYSTEM 1. DESCRIPTION The S418 automated system for swing-leaf gates is an electromechanical operator which transmits its movement to the leaf by means of a Worm-screw system. The irreversible system guarantees mechanical locking of the leaf when the motor is not operating. An easy-to-use release device permits movement of the leaf in case of malfunction or a power cut.

  • Page 5: Technical Specifications

    • Hinges must be suitably sturdy and in good condition Technical specifications S418 • Mechanical opening and closing stop-points must be present on the ground (not necessary if mechanical operator stops are Power supply (Vdc) used).

  • Page 6: Installation Of The Operators

    If the size of the pilaster or the position of the hinge should not permit installation of the operator, a niche will have to be made in the pilaster in order not to change value A, as indicated in figure 6. The size of the niche must be such as to permit easy installation of the operator, not limiting its...

  • Page 7: Wiring The Operator

    ( e.g. H07RN-F). 3.6. MECHANICAL STOPS The S418 operator is supplied with mechanical stops on opening and closing as standard. These may be used in place of the mechanical stop-points for the leaf. For adjustment of the stops, proceed as follows: 3.6.1.

  • Page 8: Automated System Test

    8. REPAIRS The user must not carry out any repairs or maintenance operations; these must be effected only and exclusively by qualified FAAC personnel or FAAC service centres. 9. ACCESSORIES For the available accessories see the FAAC catalogue.
  • Page 9 Les descriptions et les illustrations du présent manuel sont fournies à titre indicatif. FAAC se réserve le droit d’apporter à tout moment les modifications qu’elle jugera utiles sur ce produit tout en conservant les caractéristiques essentielles, sans devoir pour autant mettre à...

This manual is also suitable for:

S418Safe zone s418

Table of Contents