Table of Contents
Advertisement
Parameter Menus
Set Lengths for Code 39
Parameter # L1 = 12h, L2 = 13h
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 39 may be set for any length,
one or two discrete lengths, or lengths within a specific range. If Code 39 Full ASCII is
enabled, Length Within a Range or Any Length are the preferred options.
One Discrete Length - This option limits decodes to only those Code 39 symbols
containing a selected length. Lengths are selected from the numeric bar codes beginning
on
page
9-144. For example, to decode only Code 39 symbols with 14 characters, scan
Code 39 - One Discrete Length, then scan 1 followed by 4. To change the selection or
cancel an incorrect entry, scan the
Cancel
bar code on
page
9-146.
Code 39 - One Discrete Length
Two Discrete Lengths - This option limits decodes to only those Code 39 symbols
containing either of two selected lengths. Lengths are selected from the numeric bar
codes beginning on
page
9-144. For example, to decode only those Code 39 symbols
containing either 2 or 14 characters, select Code 39 - Two Discrete Lengths, then scan
0, 2, 1, and then 4. To change the selection or cancel an incorrect entry, scan the
Cancel
bar code on
page
9-146.
Code 39 - Two Discrete Lengths
9-59
Advertisement
Table of Contents
