FANATEC ClubSport Wheel Base V2 Manual page 28

6.3.8 DRI (Drift mode)
DRI range: OFF
The drift mode reduces the overall resistance of the wheel and let you turn the
wheel more easily. It almost works like a power steering. It reduces the basic
dampening of the wheel and makes the wheel turn faster. If the values is set
too high (or if the games FFB interferes with this feature) you might experience
some oscillation. If that happens - reduce the value or turn DRI "OFF" again.
To change the used and active value press up or down direction at the Funky-
Switch of the Fanatec Steering Wheel or turn the FunkySwitch
TM
counter clockwise.
6.3.9 FOR (force), SPR (spring), DPR (damper)
FOR range: OFF
SPR range: OFF
DPR range: OFF
These force feedback modifiers give you the ability to change the force feed-
back signals of a game (only applicable if game uses these effects). In theory
there are three types of signals which a game can send: Force (pushes the
wheel into a special direction), spring (pulls the wheel towards the center) and
damper (creates friction). Not every game uses all types of effects and some
games even use only one type to create all different feelings. Using your tuning
menu in the CSW you can increase or reduce these different effects individ-
ually. To change the used and active value press up or down direction at the
FunkySwitch
wise / counter clockwise.
Note: If SPR is set to low values or 'OFF' the ClubSport Wheel Base V2 will
not be able to move the attached Steering Wheel to correct center position
after calibration run. Force, spring and damper modifiers cannot be used
on Xbox One since those separated FFB signals are not used in the XBO
force feedback system.
IMPORTANT:
force feedback effects are clearly not strong enough and weaker in com-
parison to other games. When the game sends full effects and the wheel
is set to 100% then the device will work on its power limit. Pushing up one
value to a very high number or even raising multiple values will result in
higher load on the motor and increased heat development.
28
000 ... 005
010 ... 150
010 ... 150
010 ... 150
of the Fanatec Steering Wheel or turn the FunkySwitch
TM
Please do only set these values higher than 100% if the
DRI default: OFF
FOR default: 100 (%)
SPR default: 100 (%)
DPR default: 100 (%)
clockwise /
TM
clock-
TM