FANATEC ClubSport Wheel Base V2 Manual page 24

When the update is done the Club-
Sport Wheel Base V2 must be restart-
ed by pressing the button 'Restart
Wheel' which is available after firm-
ware update is completely finished as
shown on the right hand side:
The ClubSport Wheel Base switches
off and automatically on again.
IMPORTANT:
and by driver so that usually it is not possible to install wrong firmwares
on the ClubSport Wheel Base V2! Do not try to force installation of any
wrong firmware to the ClubSport Wheel Base V2 to avoid damages.
IMPORTANT:
Sport Wheel Base V2 must be manually calibrated again. This is also in-
dicated by the LED display of the steering wheel showing 'CAL'. This
appearance will be gone after manual calibration of the wheel center. See
chapter 'Hotkeys'
IMPORTANT:
to the ClubSport Wheel Base V2 must be manually calibrated again. See
chapter 'Hotkeys'
24
The ClubSport Wheel Base V2 is secured by firmware
After firmware update the center position of the Club-
'Wheel center calibration' for more details.
After firmware update the H-pattern shifters connected
'Shifter calibration mode' for more details.