If you go to the PC driver page 'Update' you will see this window:
In this window you can see the following informations:
•
Currently installed and used PC driver version
•
Currently installed and used firmware version on the ClubSport Wheel
Base V2
•
Quick link to the Fanatec homepage www.fanatec.com
Below the shown information there is the button 'Update ClubSport Base Firm-
ware'. When pressing this button the firmware update process for the Club-
Sport Wheel Base V2 will be started (see more detailed description in chapter
'Firmware update procedure' below in this user manual).
6.1.2 Firmware update procedure
To initiate the firmware update the ClubSport Wheel Base V2 must first be
connected to the PC by USB cable and then it must be switched to Bootloader
mode. You can switch to Bootloader mode in two different ways:
•
by PC driver, on page 'Update' press the button 'Update ClubSport Base
Firmware' when the ClubSport Wheel Base V2 is switched ON, see
previous chapter 'PC' driver
•
by pressing the red power button 'START' on the front plate of the
ClubSport Wheel Base V2 for about 8 seconds when the ClubSport Wheel
Base V2 is switched OFF.
21