FANATEC ClubSport Wheel Base V2 Manual page 18

Indicator bar shows the current Steering
Wheel position, the upper box shows the posi-
tion in digits, the lower box shows the position
as an angle (positive and negative angle re-
lated to the calibrated wheel center position).
The button 'display test' activates a signal flow on the LED display of the at-
tached Fanatec Steering Wheel and activates all LED display segments so you
can check if all LED display segments work properly.
The button 'FFB test' starts a force feedback test and activates the motor of the
ClubSport Wheel Base V2 to check proper functionality.
The button 'Rev LEDs test' starts a signal flow on the LED bar on the Steering
Wheel top side and activates them to test proper functionality of each single
LED. This is not available for the ClubSport Universal Hub as this one has no
LED bar.
The button 'Vibration Test' starts a vibration signal to activate the vibration mo-
tors inside the Fanatec Steering Wheels. This is not available for the ClubSport
Universal Hub as the Universal Hub rims do not have vibration motors inside.
18
The three indicators 'Clutch', 'Brake' and 'Throttle' show the
current activation and position of these single pedals by a
blue bar moving up and down. Therefore the pedals must be
connected to the ClubSport Wheel Base V2.
Note: Every pedal lever must be pressed down completely to
auto-calibrate the lever movement distance each time when
power resumes.
The 'D-pad' arrows (up, down, left, right) change their col-
our from black to blue when the corresponding direction is
pressed on the attached Fanatec Steering Wheel.
The 'Rotary Encoder' boxes flash blue when turning left or
right the FunkySwitch (clockwise or counter-clockwise).
TM