Mains Power Connection; External Unit; Connecting To A Tv - TechniSat Digit ISIO S2 Quick Start Manual

The following references (a b c etc.) relate to the illustration on page 18.

4.1 Mains power connection

The digital receiver should only be connected to the mains power supply once you have
finished making all the connections to the various other components. This will prevent
damage to the digital receiver or other components.
Once you have made all the other connections in accordance with the following
a
sections, use the power supply unit supplied to connect the receiver to a
230 V/50-60 Hz mains power outlet.

4.2 External unit

4.2.1 Operating with 2 antenna signals
To be able to use the full scope of functions on the digital receiver you should operate the
receiver on two separate antenna signals/antenna cables that are identically set up.
b, c Use appropriate coaxial cables to connect the LNB Inputs 1 and 2 on the digital
receiver to your external unit.
Note Section 7.6 (Antenna Settings) as well.
4.2.2 Operating with 1 antenna signal
In exceptional cases you can also operate the receiver using just one antenna signal.
However, in this event the recording and PiP functions are only available to a limited extent.
(see section 7.6.3)
Connect the LNB input 1 on the digital receiver to your external unit using a suitable
b
coaxial cable.
4.2.3 Operating with a rotating system
During operation on a rotating system, connect the DiSEqC motor (level 1.2) with LNB
b
input 1.

4.3 Connecting to a TV

Connect the receiver (HDMI output) and TV receiver (HDMI input) using an HDMI
d
cable.
If your TV set is equipped appropriately, it will automatically switch to the HDMI input
when the digital receiver is switched on.
Alternatively:
Connect the receiver (mini TV SCART socket) and the TV (SCART socket) via
a mini SCART adapter (e.g. part no. 0000/3602) and a SCART cable.
If your TV is equipped appropriately, it will automatically switch to AV - and hence
satellite mode - when the digital receiver is switched on. It may be necessary to adjust
the signal type on your TV (see section 7.3.6).
9