TechniSat Digit ISIO S2 Quick Start Manual page 41

Fault
Receiver cannot be
operated, switched on or off
USB device not recognised
Device automatically
switches off after a certain
time
Possible cause
Defective data stream -->
receiver blocked
USB device formatted for
wrong file system
Auto Standby function
enabled
41
Solution
Hold down the On/Stand-by
button on the receiver or the
remote control for approx.
5 seconds.
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver
Perform Flash-Reset:
Warning!
All personal settings will be
lost.
> Remove mains adapter
from the receiver
> Press and hold
Standby and the up
arrow key on the device
at the same time.
> Reinsert the mains
adapter while Standby
and the up arrow key
are pressed down
> Keep both buttons
pressed down for approx.
5 sec. then release.
"Factory setting"
appears in the display.
Format USB device for
FAT32 file format
Check Auto Standby setting
and disable if necessary.
(see section 7.2.7)