Install The Aileron Servo - GREAT PLANES Gitabria Instruction Manual

❏
6. Operate the rudder and elevator, checking that the
pushrods do not bind in the pushrod guides. Adjust the position
of the pushrod guides so that the pushrods are straight and
the guides are 90 degrees to the fuselage. Glue the pushrod
guides to the fuselage with foam-safe CA.

Install the Aileron Servo

❏
1. Use foam-safe CA to glue the aileron servo doubler to
each side of the fuselage.
❏
2. Connect the aileron servo to the receiver and center
the servo arm. Place the ABS servo arm extension on the
underside of the servo arm. If you are using Futaba servo arms,
the holes in the servo arm and the holes in the servo arm
extension will align. If you are using another brand of servo
arm, you may need to drill a pilot hole with a #60 [1mm] drill
bit in the servo arm that will align with the mounting holes in
the servo arm extension.
❏
3. Attach the servo arm extension to the servo arm using
two 3/64" [1.2mm] self tapping screws.
❏
4. Install the aileron servo arm on the aileron servo. Make
sure the servo arm is centered. Once the servo is installed,
removal of the servo arm is diffi cult.
❏
5. Use foam-safe CA to glue the aileron servo to the
fuselage. Make sure the aileron servo wire is on the right
side of the fuselage.
12