Handlebar Tilt (Bearcat Models); Handlebar Tilt (T570/Tz1 Standard Models) - Arctic Cat Bearcat 570 Operator's Manual

Code
8 Open or short circuit in manifold air
pressure sensor.
9 Failure in crankshaft position sensor.
11 Failure in speed sensor.
12 Failure in coil (MAG).
13 Failure in coil (PTO).
14 Failure in ISC valve.
15 Failure in oxygen sensor.
19 Failure in camshaft position sensor.
21 Failure in knock sensor.
22* Failure in Injector (PTO secondary).
23* Failure in Injector (MAG secondary).
25 Failure in shifting system/gear
OCTN* Low octane gasoline.
* Turbo models
HANDLEBAR TILT
(Bearcat Models)
The handlebar can be adjusted to the
position providing the operator with
the most comfort. To adjust the handle-
bar, use the following procedure:
 NOTE: It may be necessary to
remove the handlebar cover for
this procedure.
1. Loosen the four lock nuts securing
the handlebar caps and block to
the steering post.
2. Adjust the handlebar to operator's
desired tilt; then tighten the lock
nuts evenly and securely. Check
steering for maximum right/left
turning capabilities.
14
Trouble
position switch.
743-442A
3. Recheck
securely.
 NOTE:
Recommended
value of lock nuts is 18 ft-lb.
 NOTE: Do not rotate the handle-
bar to a position that allows air to
enter the brake system.
! WARNING
Tighten lock nuts according to
specifications to prevent unex-
pected "movement" of the handle-
bar during operation over rough
terrain and DO NOT position han-
dlebar so steering (maximum right/
left turning capabilities) or throttle
and brake controls are affected.
HANDLEBAR TILT
(T570/TZ1 Standard
Models)
The handlebar can be adjusted to the
operator's preference. To adjust the han-
dlebar, use the following procedure:
1. Loosen the four cap screws and
lock nuts securing the handlebar
caps to the riser and the riser to the
steering post.
2. Adjust the handlebar to operator's
desired tilt, tighten the lock nuts/
cap screws evenly to 25 ft-lb, and
check steering for maximum right/
left turning capabilities.
 NOTE: Do not rotate the handle-
bar to a position that allows air to
enter the brake system.
GENERAL INFORMATION
lock nuts; tighten
torque
744-439A