Table of Contents
Advertisement
2. Open the air bleed bolt located on
the oil pump (beneath the coolant
tank) to purge air from the oil
hose.
NOTE: When air can no longer
be heard purging from oil pump
bleed, tighten the bleed bolt to 7.5
ft-lb.
CAUTION
Do not attempt to start the engine
with the bleed bolt open.
3. Start the engine. The warning light
should go out within five seconds.
4. If the warning light does not go
out, shut the engine off immedi-
ately and repeat step 2; then repeat
step 3.
If the warning light does not go out or
if the engine does not start, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer. If not under
warranty, this service is at the discre-
tion and expense of the snowmobile
owner.
SPEEDOMETER /
TACHOMETER
INDICATOR ICONS
(Deluxe Gauge)
Certain models (TZ1 LXR/LE models)
are equipped with a deluxe gauge com-
bination speedometer/tachometer. Indi-
cator icons are incorporated within the
speedometer/tachometer. Also incorpo-
rated into the speedometer/tachometer
is a digital readout screen.
10
A. High Beam
B. Oil Pressure/Low Oil
C. Coolant Temperature
ZJ004A
D. Increment Button
E. Select Button
F. Decrement Button
G. Service
H. Charging System
RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one
with the needle). By pushing the button
once again, the functions will be
reversed.
By pushing the increment button (with
speed being displayed) for more than
two seconds, the display will change
between standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the
increment button, maximum RPM will
be displayed on the readout screen. The
maximum RPM readout will reset
when the decrement button is pushed
(while maximum RPM is displayed).
GENERAL INFORMATION
FZ001A
Advertisement
Table of Contents
