Table of Contents
Advertisement
Odometer/Trip-Meter
(1)/Trip-Meter (2)/
Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the
trip meter displayed, push and hold the
decrement button until the display is
cleared. The hour-meter readout will
not reset.
Clock/Altimeter
By pushing the select button, the read-
out screen will display clock, altimeter,
and maximum altimeter.
With clock selected on the display by
pushing and holding the select button
for two seconds, the option of selecting
the 12-hour or 24-hour clock mode is
available. Push the increment button to
toggle between the 12-hour display and
the 24-hour display. When desired mode
is displayed, push the select button.
At this point, the hours display will
begin to flash. Push the increment but-
ton to increase the hours; push the dec-
rement button to decrease the hours.
Pushing and holding a button will
accelerate the number display. When
desired hour number is displayed, push
the select button.
At this point, the minutes display will
begin to flash. Push the increment but-
ton to increase the minutes; push the
decrement button to decrease the min-
utes. Pushing and holding a button will
accelerate the number display. When
desired minute number is displayed,
push the select button.
NOTE: During clock setting if no
button
(increment,
select) is pushed within a 5-sec-
ond time period, the clock-setting
mode will be exited with changes
saved.
GENERAL INFORMATION
The altimeter readout is based off baro-
metric pressure and may require cali-
bration as weather conditions change.
To calibrate the altimeter to an estab-
lished altitude with altimeter selected
on the display screen by pushing and
holding the select button for a mini-
mum of two seconds, the acronym
CAL will be displayed on the readout
screen for one second; then the altitude
value will flash. Push the increment
button to increase the displayed alti-
tude; push the decrement button to
decrease the displayed altitude. Push-
ing and holding a button will accelerate
the number display.
NOTE: If MPH has been selected
in the speed readout, the altitude
value will be displayed in feet. If
kph has been selected in the
speed readout, the altitude value
will be displayed in meters.
To reset the maximum altimeter read-
out with the maximum altimeter dis-
played, push and hold the select button
for a minimum of two seconds.
Service Icon
On electric start models, the icon should
illuminate each time the key is turned to
RUN or START, and it should go out
when the engine starts. If the icon stays
illuminated (on electric start models) or
it illuminates while the engine is run-
ning, the system is receiving input that
is outside of its established parameters.
If the system icon illuminates indicating
an error, take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for service. If not under warranty,
this service is at the discretion and
expense of the snowmobile owner.
decrement,
11
Advertisement
Table of Contents
