Fill Clear Water Tank; Empty Clear Water Tank; Clean Clear Water Filter - HAKO Scrubmaster B120 Instruction Manual

Maintenance and Care
5.5.1 Fill Fresh Water Tank
Fill fresh water tank (Fig. 8/1) before
work or as required. Park vehicle on le-
vel ground. Open tank lid (Fig. 8/5) and
fill tank with fresh water up to the maxi-
mum (1/1 marker) (Fig. 8/2).
Alternatively, filling of the machine via
quick coupling (Fig. 8/6) is available.
Before doing so, connect the filling hose
of the dosage unit and the quick cou-
pling. The floater valve automatically
closes after the maximum filling level
has been attained.
(Refer to specific operating instructions
for information on operation of the do-
sage unit)
The maximum admissible service pres-
sure of the floater unit is 6bar.
5.5.2 Empty Fresh Water Tank
Park vehicle such that the fill level hose
(Fig. 8/3) is located above the drain
aperture in the floor. Take fill level hose
from holder and remove lid.
5.5.3 Clean Fresh Water Filter
Check fresh water filter (Fig. 8/4) at
weekly intervals and clean or replace if
required.
Only clean water filter with
emptied fresh water tank.
1. Empty fresh water tank (Fig. 8/1)
entleeren, see paragraph 5.5.2.
2. Unscrew filter cap.
3. Remove the filter element from the
filter case for cleaning. Replace if re-
quired.
4. Re-install filter element and filter
cap.
31